How to Build Your Own Sliding Door
🕒 3 Minutes Reading Time -
DIY Sliding Wardrobe Doors: Build & Install Your Own Sliding Door System
Sliding doors are perfect for saving space in bedrooms, hallways and attics. With accurate measuring, clean cutting and proper rail installation, you can build a custom sliding wardrobe or room divider that fits your space exactly. This guide walks you through every step using compact, powerful Batavia tools.
What you’ll learn
Recommended tools
- 12V Cordless Circular Saw 85mm – precise straight cuts for smaller panels
- 18V Cordless Mini Circular Saw 89mm – powerful and controlled cutting for MDF & plywood
- 18V Cordless Brushless Jigsaw – perfect for handle cut-outs and internal shapes
- 18V Cordless Brushless Combi Drill 60 Nm – for accurate drilling and secure rail installation
Step 1: Measure & calculate door size
Measure the full opening width and height. If using multiple doors, add 2–5 cm overlap to prevent visible gaps.
- Opening width: 200 cm
- Overlap: 2 cm
- Total: 202 cm
- Two doors: 202 / 2 = 101 cm each
Always subtract wheel height from total door height before cutting.
Step 2: Cut the panels
Use a circular saw for long straight cuts. Support the panel properly and cut slowly for clean edges.
For detailed shapes or recessed handles, drill a starter hole and use the 18V Brushless Jigsaw.
Step 3: Mount wheels & guides
Pre-drill mounting holes using the 18V Cordless Brushless Combi Drill 60 Nm.
- Mark wheel positions carefully
- Pre-drill pilot holes
- Mount bottom wheels securely
- Install top guides with minimal clearance
Step 4: Install the rails
Install the bottom rail first, securing it every 50 cm. Then align the top rail directly above it.
Step 5: Hang & adjust
Insert the door into the top rail first, then position the bottom wheels onto the lower rail. Start with the rear door if using multiple panels.
- Check smooth movement
- Adjust stoppers
- Verify overlap alignment
FAQ: DIY sliding doors
How thick should sliding doors be?
18 mm MDF or plywood offers the best balance between strength and workability.
Should I use a circular saw or jigsaw?
Use a circular saw for straight cuts and a jigsaw for internal shapes or cut-outs.
Why do sliding doors stick?
Most issues are caused by rail misalignment or uneven wheel positioning.
Ready to build your own sliding system?
With the right measurements, precise cuts and solid drilling, building your own sliding wardrobe system is easier than you think.
